Turn the power off and unplug the printer. Wait 20 minutes for the printer to cool.

Open the back door of the printer, using enough force that the door opens completely and the hinge locks disengage, as shown below.

Remove the 2 screws (holes circled in yellow below) which hold the rear cover in place. Rotate the bottom of the rear cover outwards to free & remove the panel.

Next you can remove the duplexer inlet guide. Release the holding tabs upwards as shown below.

Pry off the white plastic sidecover to the left to remove it.

With the rear cover and side cover removed, you can unplug the 3 fuser connectors circled in blue below. Also , remove the 4 metal screws circled in red below.

Next remove the fuser. Often you have to wiggle the fuser a bit from side to side to remove it.

You can insert the new fuser , replug all 3 wires and reinstall the 4 screws.

Reinstall the duplexer paper guide, the small white side cover, and the rear cover.

• Pin It
• Share
• Tweet

Be Sociable, Share!

• 

Related posts:

1. How to Install “Internet Information Service” in Windows XP
2. Unable to un-install any software?
3. C++ programs – Implement the Queue ADT using an array
4. C++ program to implement Queue using Formula Based Representation
5. C++ program to implement circular queue using array

Tagged as: fuser, fuser installation, How to install HP LaserJet P3005 Maintenance Kit - Fuser, hp P3005, hp P3005 fuser, hp P3005 Maintenance Kit, hp printer fuser, Maintenance Kit Installation, P3005, printer fuser, printer fuser installation, printer How to install HP LaserJet P3005 Maintenance Kit, printer Maintenance Kit Installation