A seven segment display is the most basic electronic display device that can display digits from 0-9. They find wide application in devices that display numeric information like digital clocks, radio, microwave ovens, electronic meters etc. The most common configuration has an array of eight LEDs arranged in a special pattern to display these digits. They are laid out as a squared-off figure ‘8’. Every LED is assigned a name from ‘a’ to ‘h’ and is identified by its name. Seven LEDs ‘a’ to ‘g’ are used to display the numerals while eighth LED ‘h’ is used to display the dot/decimal.
A seven segment is generally available in ten pin package. While eight pins correspond to the eight LEDs, the remaining two pins (at middle) are common and internally shorted. These segments come in two configurations, namely, Common cathode (CC) and Common anode (CA). In CC configuration, the negative terminals of all LEDs are connected to the common pins. The common is connected to ground and a particular LED glows when its corresponding pin is given high. In CA arrangement, the common pin is given a high logic and the LED pins are given low to display a number.
Pin Diagram:
Numbers to 7-segment-code
A single byte can encode the full state of a 7-segment-display. The most popular bit encodings are gfedcba and abcdefg – both usually assume 0 is off and 1 is on.
This table gives the hexadecimal encodings for displaying the digits 0 to F:
Not Satisfied ? Just search & get the result
No related posts.
